We spent about two hours on Sunday. Part of that time was spent getting the inboard wing channel into place, and the rest on the flaperon brackets.

I believe that my rear wing channels may be a few mm aft, as I am having a problem with 7V4-6.

When I attempt to place the bracket, the after edge is more rearward than the rib. If I move the bracket forward then it gets between the rib and the channel.

Is the correction to attempt to move the channel forward, or to shim between the rib and the channel?

Project Status:
Wings: 36.5h ( 1h, 1h, 0.5h, 2.5h, 4h, 1h, 1.5h, 1h, 1.5, 4.5, 1h, 1h, 2h, 4h, 1h, 3h, 1h, 2h, .5h, 1.5h, 2h )
Flaperons: ( DONE! ) 23.5 hours spent ( 3h, 1h, 1h, 1h, 1.5h, 3h, 6h, 3h, 4h, 1h )
Paint Design: 2 hours spent ( 1h, 1h )
Elevator DONE!: ~31.5 hours spent ( 3h, 1.5h, 3h, .5h, 3.5h, 2h, 4h, 1.5h, 2h, 4.5h, 1h, 6h )
Horizontal Stabilizer DONE!: ~28 hours spent, 3 pieces replaced ( 3h, 2h, 2h, 2h, .5h, 1.5h, 3.5h, 1.5h, 5, 4.5, 2h, .5h )
Rudder DONE!, minus horn : ~16 hours spent, ( ~8h, ~8h )
-----------------------
Total Done: ~139 hours